Note: In the event that your printer contains multiple trays, the following kit is available for trays 2 through 6: Z1750 (HP CB506-67904 Paper Feed Kit) In the event that you may need to replace just one type of roller, the individual rollers are listed below:įor the tray 1 feed roller only, use the following part: B8037 (HP RL1-1663-000 Feed Roller Tray 1)įor the tray 1 pickup roller only, use the following part: B8038 (HP RL1-1641-000 Pickup Roller, Tray 1)įor the tray 1 separation roller only, use the following part: B8036 (HP RL1-1654-000 Separation Roller Tray 1) Note: This article is written to provide instructions on the replacement of all components in the paper feed kit (pickup roller, feed roller, and separation roller). If the error persists, replace the Tray 2 pickup solenoid (SL101).To order your replacement paper feed kit for this printer, use the following part: Z4990 (HP CB506-67905 Tray 1 Paper Feed Kit) If the solenoid is not being energized, verify that the solenoid connector is attached to connector J72 on the DC controller PCA. Listen for an audible “click” when the test is initiated. From the DIAGNOSTICS menu, run the Tray 2 pickup solenoid component test to verify that the solenoid moves when energized. If maintenance has recently be performed, verify that the pickup, feed, and separation rollers have been reinstalled correctly. Inspect the paper path and ensure no obstacles are blocking the paper path. Description: The paper path might have an obstruction, or the Tray 2 solenoid might not be working correctly.
If the error persists, replace the Tray 1 solenoid (SL102). If the solenoid is not being energized, verify that the solenoid connector is attached to connector J71 on the DC controller PCA.
From the DIAGNOSTICS menu, run the multipurpose tray (Tray 1) solenoid component test to verify that the solenoid moves when energized. If someone has performed maintenance on the product recently, verify that the Tray 1 pickup roller, feed roller, and separation roller have been installed correctly. Load paper in Tray 1, and then use the paper path test to pull paper.
#HP LASERJET P4015N TRAY SERIAL#
If the initialization routine is successful, you will need to re-enter several configuration parameters (such as the page count and the serial number). If possible, print a configuration page to record product information, and then perform an NVRAM initialization routine. Power cycle the product to see if the message clears. Description: The real time clock has experienced an error.Turn the product off and then on to clear the message.Values of XX and YY are listed below: XX00 = memory is defective XX01 = memory is missing YY00 = cartridge Description: An error has occurred in one or more of the product's supplies.Reinsert the print cartridge and then close the top cover. Remove the plastic insert and foam from the print cartridge area. Remove the orange tabs from the print cartridge. Pull the tape and then remove the print cartridge. Description: At least one shipping lock is installed.Display: 10.94.YY REMOVE SHIPPING LOCKS FROM CARTRIDGE.Verify the connector at J74 on the DC controller PCA is securely connected. Ensure that the cartridge is a genuine HP print cartridge. Description: The product has experienced a print cartridge error.